Disassembly and Cleaning Tips
1. Unplug the power cord from the power cord connector on the rear side of the motor base unit.
2. Lift the Clamp up to release.
3. Hold the motor base unit and slide the screen housing off.
* When the screen housing is not released smoothly:
1) Plug the power cord into the electrical outlet.
2) Turn the main (red rocker) switch ON.
3) Press START button and then, slowly pull the screen housing out with careful attention. The twin gears will be stopped automatically.
4) Turn the main (red rocker) switch OFF.
5) Unplug the power cord from the electrical outlet.
.
4. Carefully pull the Twin Gears out, holding with both hands.
5. Remove fibres on the screen area with the Screen Cleaning Knife.
* Tips for cleaning the Screen:
1) The juicing screen is the hardest part of any juicer to clean, so cleaning immediately after juicing is best, as the pulp comes off faster and easier.
2) The stainless steel parts of the Angel Juicer can also be washed in a dishwasher, which makes cleaning even easier.
3) The tiny holes in the juicing screen of all cold press juicers eventually become clogged, which causes the juice to back up the chute and slows down juicing. A simple and effective way of cleaning the screen is to soak it overnight.
.
6. Clean the Screen Housing and Twin Gears with the Cleaning Brush under the running water.
* Tips for cleaning the Screen Housing:
Slowly insert the Cleaning Brush into the Screen Housing and then pull the Cleaning Brush out by turning clockwise continuously. Repeat this step 4 or 5 times.
.
In order to extend the life span of juice extractor, you need to clean all parts immediately after use, before mineral build-up which can cause problems.
.
Tips for Cleaning your Juicer:
Maintaining maximum cleanliness of your juicer is extremely important for both your health and the peak performance of the machine. We recommend cleaning the juicer immediately after use, since cleaning the machine as quickly as possible is the easiest way to remove food articles.
1. MINERAL SCALES: After using the machine for some time, you may notice a calcium or mineral deposit on the surface of the twin gears.
This mineral deposits may be removed from the tips of the twin gears by running soaked almonds through the machine. Another excellent way to remove mineral scales is to soak those affected parts in a pure vinegar bath overnight. This loosens the scaling and much of it can be brushed off. This process maybe repeated as necessary. The vinegar used for de-scaling can be stored for reuse. Please label the storage bottle properly so that it is not accidentally used in food preparation.
Tips: To prevent mineral scales, thoroughly clean the twin gears with warm water immediately after juicing. If delays on above cleaning, the mineral deposit starts to build up (It looks like a very thin film on the surface of the twin gears).
2. STICKY RESIDUE: Dried fruits and nuts can be very sticky on the inside surface of the
juicer. To remove the residue more easily, run a couple of stalks of celery through the machine before disassemble the machine.
3. MOTOR BASE UNIT: Wipe the exterior surfaces with a damp cloth and dry with a clean towel. For keeping the best polish, clean the parts with the soft sponge first and dry it with the soft towel. After cleaning the juice extractor, let it dry thoroughly.
It is not recommended that harsh chemical, such as bleach, be used to remove food stains from the juice extractor.
.